Martech 79035 The Solution with 35' Hose

Martech 79035 Cleaning, drying, and heating the atomizing air from your existing compressed air source can be accomplished with The Solution by Martech Services Company. The four-stage filtration is outfitted with an automatic moisture discharger. Then the clean air is further filtered to remove moisture content for super dry air. A controller, with digital outputs, allows user to set the temperature of the atomizing up to 165 degrees F. The Solution is shipped complete with a 3/8” ID x 35’ spray air hose. The Solution is a complete compressed air system designed to clean, dry, and heat the atomizing air for today’s spray paint requirements. It is easy to use, simple to install, and affordable to maintain. Works well with both waterborne and solvent based paint systems.

Easy to install, on the exterior of a new or existing spray boothWorks with the existing compressed air systemProvides clean, dry, filtered air to .01 micronMaximum sweep air of only 3% to 4%Easy, low cost maintenance of the four-stage filterAutomatic moisture discharger, standardPanel mounted, ready to install, includes all necessary fittingsSelf-relieving pressure regulator with gaugeOperates on 110 VAC with less than 4 amp drawDigital control panel to set the atomizing air temperature from 100° F to 165° F35' x 3/8" heated hose assembly with 1/4" NPT large bore male endSystem on/off control with LED indicator lampFlow rate at a maximum of 35 CFMMaximum input pressure of 150 PSI